Languages
Ring Packing Cutter
SUNWELL T900GPRC
SUNWELL Ring packing cutter permits accurate cutting of rings from spiral or flat coil packings. The scale reads directly in terms of shaft sizes. In inches and in millimeters.
PDF Download- Specification
- You may also like
Guillotine Braided Packing Ring Cutter is mainly composed of a cutting tool and a cutting tool holder, it is used to cut braided packing ring in 15 or 45 degree angle.
Cutting range:
Braided Packing | 3mm to 28mm |
Shaft Size | Up to 4” (100mm) |
Performance:
1. The SUNWELL guillotine braided packing cutter is made of alloy (The base plate made by steel with the anti-rust coating treatment, no rust for a long time using, cutting knife made by high-strength blade steel)
2. It can easily cut various kinds of braided packings such as Aramid, Steel or inconel reinforced packings.
3. Unique structure design, clear scale ruler can accurately cut the right size of packing and reduce the cutting error.
4. The unique fixture design can avoid the loosening of the cutting edge of the packing.Calculation on site.
5. Scientific size conversion design, save the time of change different sizes.
Portable, economical and practical.
Cutting Method:
1. Install the cutting tool on the cutting tool holder and fix it with screws.
2. Select the packing to be used to determine the required cutting size.
3. Perform straight cut 15o or 45o oblique cut.
The scale on the sliding ruler is used to measure the length of the packing. That’s the perimeter of the shaft of the 3.14(π) x diameter of the packing ring. Make sure the packing can’t be rotated at will when performing 45o bevel cut. In the case of straight cutting, different cutting points need to be rotated 180o each time, no matter waht kinds of cutting. It should be operate carefully
Tips:
1. The first time using, you may not be accustomed to the strength of the handle when using a new guillotine braided packing ring cutter. You only need add more force to the rear end of the blade.
2. Due to the wide variety of cutting packing and different properties, the adjustment of the scale will be slightly deviated. Therefore, before processing large quantity of packing, it’s been recommended to cut one carefully and verify that it is correct before proceeding. Doing the first piece checking irregularly during operation to ensure that the front and back sizes are correct when you set the cut to a packing of a certain size and models.
